- 3D Product Video
- 2012 New Products
- New products
- Residual current device(RCD)
- RCD protected
- Mini circuit breaker(MCB)
- Mini bircuit breaker(black)
- Moulded case circuit breakers(MCCB)
- Residual current breaker overload
- Magnetic-hydraulic circuit breaker
- DC circuit breaker
- Automatic Transfer Switch
- Moulded case circuit breaker
- Motor protection circuit breaker
- Main switches & fuse switch disconnector
- Moduler device
- Circuit breaker auxiliary accessories
- Distribution box
- Surge device and lighreting
- Weatherprotected switch and socket
- Air circuit breaker
- Vacuum circuit breaker（VCB）
- Wifi circuit breaker & switch & socket
- Timer and door alarm
- Industrial electrical
- Radio controller
- Photo and time controls
- Magnetic switches
- Ground fault citcuit interruptor with cover
- Cam starter
- Switches series
- Breaker producing equipment
- Parts of circuit breaker
- Power Inverter
- Piercing connector
- Metallzed film for capacltor
- Energy meter
- Surge protective device
- Thermostat & temperature controller
- Vacuum components
- Box cover of lighing fitting
- Wiring accessories
- Float switch
- Power fitting
- Electric power
- Industrial switch
- Explosion-proof electrical
- Weatherproof switches
EM231EI THREE PHASE FOUR WIRE ELECTRONIC DIN-RAIL REACTIVE ENERGY METER
Model EM231EI three phase four wire electronic DIN rail reactive energy meter is a kind of new style three phase four wire reactive energy meter, it adopt micro-electronics technique, and imported large scale integrate circuit, use advanced technique of digital and SMT techniques, etc. The meter completely accord with relevant technical requirements of class 2 three phase reactive energy meter stipulated in international standard IEC 62053-21. It can accurate and directly measure 50Hz or 60Hz active energy consumption from three phase four wire AC electricity net. It can display total energy consumption by step motor type impulse register. It has following features: good reliability, small volume, light weight, specious nice appearance, convenient installation, etc. This meter has already got the patent certificate from China State Intellectual Property Office at present. Patent certificate NO. ZL 2006 3 0107349.1, any other country patent certificate are in assessing.
Functions and features
● 35mm standard DIN rail installation, complying with standard DIN EN50022. Or front board installed (mounting holes center distance 63 mm), users can choose any one by themselves.
● Ten pole width (Modulus 12.5mm), complying with standard JB/T7121-1993.
● 6 digits display (999999kWh) by step motor type impulse register.
● Standard configuration one port of pulse output passive (polarity), May select increase a distant port of pulse output passive (nonpolarity), (Product Configuration code is DF). And contact with all kind of AMR system conveniently, Complying with standard IEC 62053-31 and DIN 43864.
● Four LED instructions respectively every power supply state and signal of energy impulse.
● Automatic detection the direction of the flow of load current. And Instructions on individual LED
● Single direction three components measure three phase four wire reactive energy consumption. It is nothing with direction of the flow of load current. Complying with standard IEC 62053-23.
● May select two components measure three phase three wire active energy (Product Configuration code is EH) or two phase three wire active energy (Product Configuration code is EG)
● Direct connect operation, type S wiring (Inlet from bottom, outlet from top).
● Short terminals cover, it is use for reduce mounting space, and make mounting conveniently.
3 x 127/220
AC voltage 4kV for 1 minute,
Outer and mount dimension
Wiring diagram (Type S)
|L1||L1 phase line|
|L2||L2 phase line|
|L3||L3 phase line|
|N||Neutral line (Inlet from bottom, outlet from top)|
|7 and 8||Port of pulse output passive|